Appendix C 631
List of Default Values
List of Default Values, Save/Recall Settings, and Backup Settings
C. List of Default Values
Key Operation Factory-shipped Setting Default Value Save/
Recall
Backup Available
Means of
Defining a
Setting
*RST
S11 ← ← √ K/C
Sss11
(When Fixture Simulator is set on,
set Topology at SE-Bal, and, BalUn
on in Analysis mode)
← ← √ K/C
Sdd11
(When Fixture Simulator is set on,
set Topology at Bal-Bal, and BalUn
on in Analysis mode)
← ← √ K/C
Sss11
(When Fixture Simulator is set on,
set Topology at SE-SE-Bal, and
BalUn on in Analysis mode)
← ← √ K/C
Log Mag ← ← √ K/C
Divisions 10 ← ← √ K/C
Scale/Div 10.000 dB/div ← ← √ K/C
Reference Position 5 Div ← ← √ K/C
Reference Value 0.0000 dB ← ← √ K/C
Electrical Delay 0.0000 s ← ← √ K/C
Phase Offset 0.0000 ° ← ← √ K/C
Allocate Channels ← ← √ K/C
Number of Traces 1 ← ← √ K/C
Allocate Traces ← ← √ K/C
Display Data ← ← √ K/C
Data Math OFF ← ← √ K/C
Equation OFF ← ← √ K/C
Title Label OFF ← ← √ K/C
Graticule Label ON ← ← √ K/C
Invert Color OFF ← ← √ K/C
Frequency ON ← ← √ K/C
Update ON ← ← √ K/C
Avg Factor 16 ← ← √ K/C
Averaging OFF ← ← √ K/C
Avg Trigger OFF ← ← √ K/C
SMO Aperture 1.5000% ← ← √ K/C
Smoothing OFF ← ← √ K/C
IF Bandwidth 70 kHz ← ← √ K/C
To Next Page
Loading...
