Agilent Technologies ENA Series

430 Chapter 13
Setting and Using the Control and Management Functions
Setting the Internal Clock
Figure 13-5 Date/Time Properties Dialog Box (“Time Zone” Tab)
Step 7. In the drop-down list box select a time zone.
Step 8. To make the summertime setting automatically, check Automatically adjust clock for
daylight saving changes
to assign the check mark (√) to it.
Step 9. Press the OK button.
Setting the Date/Time Display ON/OFF
The date/time display in the instrument status bar can be switched on/off using the
following procedure.
Step 1. Press .
Step 2. Press Misc Setup.
Step 3. Press Clock Setup.
Step 4. Press Show Clock to switch the date/time display on/off.