Agilent Technologies ENA Series

60 Chapter 3
Setting Measurement Conditions
Initializing Parameters
Initializing Parameters
The E5070B/E5071B has three different initial settings as shown in Table 3-1 below.
Table 3-1 E5070B/E5071B Initial settings and methods for restoring them
Initial setting Restore method
Preset state
• Press - OK on the front panel
*1.Initialization may be executed without displaying the OK or Cancel button, depending
on the instrument setting state. For more information, see
“Showing/hiding the confir-
mation buttons when presetting” on page 449.
*1
or
• Execute the :SYST:PRES command
*RST state Execute the *RST command
Factory default setting (how the E5070B/E5071B is set up prior to shipment
from the factory)
The user can set items to be preset freely. For more information, see“Setting the user preset
function” on page 449.
For further details of each setting, refer to Appendix C, “List of Default Values,” on
page 629. To restore initial settings using commands, refer to the Programmer’s Guide and
VBA Programmer’s Guide.