Agilent Technologies ENA Series

Chapter 16 549
Specifications and Supplemental Information
General Information
16. Specifications and
Supplemental Information
Handler I/O Port 36-pin centronics, female; provides connection to handler system
Line Power
*2
Frequency 47 Hz to 63 Hz
Vo l t a g e 90 to 132 VAC, or 198 to 264 VAC (automatically switched)
VA M a x 350 VA max.
*1.USB Test and Measurement Class (TMC) interface that communicates over USB, complying with the IEEE 488.1
and IEEE 488.2 standards.
*2.A third-wire ground is required.
Table 16-18 EMC, Safety and Environment
Description Supplemental Information
EMC
European Council Directive 89/336/EEC, 93/68/EEC
IEC 61326-1:1997 +A1:1998 / EN 61326-1:1997 +A1:1998
CISPR 11:1997 +A1:1999 / EN 55011:1998 +A1:1999
Group 1, Class A
IEC 61000-4-2:1995 / EN 61000-4-2:1995 +A1:1998
4 kV CD / 8 kV AD
IEC 61000-4-3:1995 / EN 61000-4-3:1996 +A1:1998
3 V/m, 80-1000 MHz, 80% AM
IEC 61000-4-4:1995 / EN 61000-4-4:1995
1 kV power / 0.5 kV Signal
IEC 61000-4-5:1995 / EN 61000-4-5:1995
0.5 kV Normal / 1 kV Common
IEC 61000-4-6:1996 / EN 61000-4-6:1996
3 V, 0.15-80 MHz, 80% AM
IEC 61000-4-11:1994 / EN 61000-4-11:1994
100% 1cycle
Note: The performance criterion B is adopted for ESD immunity test,
and criterion A for other immunity tests. Temporary deviation from test
limit due to accidental measurement of test signal is considered normal
performance.
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à la norme NMB-001 du Canada.
AS/NZS 2064.1/2 Group 1, Class A
Safety
Table 16-17 Rear Panel Information
Description Supplemental Information