NanoSuite Explorer D
Agilent Nano Indenter G200 User’s Guide D-35
To modify the Units Class:
1 Click Units Class... to open the Units Selection dialog box. Select
the class from the Class drop-down menu.
This selection will determine the content for Type.
2 Select the type from the Type drop-down menu.
3 Click OK.
Select the number of decimal places to display by using the Decimal
Places drop-down menu. The choices are constrained to zero through 15
decimal places.
The Calculated checkbox determines whether a formula is included
(selected) or excluded (cleared) from calculations.
The Results checkbox determines whether a formula is included in the
Review page and the exported results.
To specify whether a formula is included or to change the order in the
Review page and exported results:
1 Click Result Order... in Figure D-44 on page D-34.
This will open the Order Results dialog box, shown in Figure D-45.
Figure D-45Order Results dialog box
To Next Page
Loading...
