Alcatel-Lucent OmniTouch - Advanced Settings

Advanced settingsSystem Configuration
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
2-87
............................................................................................................................................................................................................................................................
The Ethernet switch may be removed and replaced without restarting servers, as long as
the network configuration remains the same. The process will temporarily sever internal
communications within the stack, with predictable disturbances to replication and
conferences that span servers.
If the backplane topology changes (e.g. due to VLAN redesign), the stack may have to be
rebooted. Backplane topology changes should be done only when the stack is quiescent
(no activity).
Advanced settings
Selecting Advanced Settings opens a new menu on the left of the screen. When you are
done with the Advanced Settings, select one of the items at the top of the screen to
proceed. These settings represent infrequently used configurations or actions (the actions
are documented in Chapter 3). The Advanced Settings menu presents the following
choices.
Note: Not all may be enabled in your software version.
• Phone Formatting Rules
• Phone Number Display Filter
• Restart Servers (see Restart servers (restart OmniTouch ACS processes))
• Edit DAS Rules
• Configure SNMP
• Configure IM Archiving (if enabled in your software)
• Configure Alarm Server
• Configure External JavaScript URL
• Configure External Hosted Frame
• Configure Collaboration Subnet
• Configure Sendmail
• Configure Bonding
• Advanced Upgrade Options (see Advanced upgrade options)
• Construct Document Conversion VM
• Route Management