Alcatel-Lucent OmniTouch - Configure Collaboration Subnet; To Change the Ip Range

Configure collaboration subnetSystem Configuration
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
2-99
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6 Enter the IP address and port where the messages are to be sent in the Alarm Server
Hostname
and Alarm Server Port fields.
........................................................................................................................................................................................................................
7 Click the Save button.
........................................................................................................................................................
E ND OF STEPS
Note: If the OmniTouch Unified Communications alarm server is unreachable,
alerts and alarms will remain in a queue on the OmniTouch ACS. Periodically, they
will be retransmitted to the OmniTouch Unified Communications alarm server until
the queue is emptied.
Configure collaboration subnet
This allows a change to the IP range if there is a conflict with the Local Network
environment where the subnet is installed.
To change the IP range
........................................................................................................................................................................................................................
1 Return to the Welcome Screen.
........................................................................................................................................................................................................................
2 Click the Configuration tab.
........................................................................................................................................................................................................................
3 Click the Advanced Settings item.
........................................................................................................................................................................................................................
4 Click the Collaboration Subnet item.
The first three octets of a Subnet Address appear.