Alcatel-Lucent OmniTouch - Restoring a Standalone Server

Restoring a standalone serverManagement Actions
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
3-21
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
11 While on the Primary, select the Monitoring tab.
........................................................................................................................................................................................................................
12 Click the Data Replication item and wait for messages to be queued.
........................................................................................................................................................................................................................
13 Enable replication on the new Secondary.
a. Click the Configuration tab.
b. Click the Database Replication item.
c. Check the Enable Replication box.
d. Click the Save button.
........................................................................................................................................................................................................................
14 While on the Secondary, select the Monitoring tab.
........................................................................................................................................................................................................................
15 Click the Data Replication item and wait for both Secondary and Primary to be in the
Connected state.
After a few minutes (dependant on database size), the Secondary Queued list will change
to Done and the system will be ready for use.
........................................................................................................................................................
E ND OF STEPS
Restoring a standalone server
There are two procedures that must be performed:
• Initial installation of the Standalone server
• Restoration of the configuration settings on the new server