Alcatel-Lucent OmniTouch - To Restore after Replacement of the Secondary Server

............................................................................................................................................................................................................................................................
To restore after replacement of the Secondary serverManagement Actions
3-14
8AL90208USAD ed01
November 20, 2008
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
11 While on the Secondary, select the Monitoring tab.
........................................................................................................................................................................................................................
12 Click the Data Replication item and wait for messages to be queued.
........................................................................................................................................................................................................................
13 Enable replication on the new Primary.
a. Click the Configuration tab.
b. Click the Database Replication item.
c. Check the Enable Replication box.
d. Click the Save button.
........................................................................................................................................................................................................................
14 While on the Primary, select the Monitoring tab.
........................................................................................................................................................................................................................
15 Click the Data Replication item and wait for both Primary and Secondary to be in the
Connected state.
........................................................................................................................................................................................................................
16 After a few minutes (dependant on database size), the Primary Queued list will change to
Done and the system will be ready for use.
........................................................................................................................................................
E ND OF STEPS
To restore after replacement of the Secondary server
This procedure assumes that a stacked system has been in operation for a while, and
regularly scheduled backups have been made.
There are three procedures that must be performed:
• Initial installation of the Secondary
• Restoration of the configuration settings on the Secondary
• Replication of the database from the Primary to the Secondary