Alcatel-Lucent OmniTouch - Serial Console

To restore configuration settings on the new Secondary
server
Management Actions
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
3-17
............................................................................................................................................................................................................................................................
Note: There may be multiple files with the following sequential extensions: *.aa,
*.ab, *.ac, etc. The filenames will appear on the Administration screen. You must
locate (by using the Browse button) and upload each individual file.
After all files are uploaded, the server automatically restores, and after restoration, the
system will reboot.
........................................................................................................................................................................................................................
5 Log into the Serial Administration console again, on the New Secondary server:
Username: admin
Password: changeme
Figure 3-10 Serial Console
........................................................................................................................................................................................................................
6 Configure any required networking information.
a. Select Networking Configuration.
b. Select the
Configure TCP/IP network parameter item.
c. Use DHCP appears. Select Yes or No and press Enter.
Figure 3-11 Use DHCP
d. Configure your network appropriately.