Alcatel-Lucent OmniTouch - To Configure each Server in a Stack

To configure each server in a stackSystem Configuration
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
2-77
............................................................................................................................................................................................................................................................
After physically configuring the servers, and going through the steps documented earlier to
set up IP addresses and other server-specific settings, do the following for each server in
the stack.
To configure each server in a stack
........................................................................................................................................................................................................................
1 Click the Configuration tab.
........................................................................................................................................................................................................................
2 Click the Stacking item.
........................................................................................................................................................................................................................
3 In the resulting window (below), enter:
–The Stacking method (Dynamic or Static)
–The Stack Name (all servers use the same stack name)
–The Node ID for the specific server you are configuring. This should be a two-digit
number that will become the first two digits of users’ conference access codes.
Note: Zero (0) is not a valid Node ID for a server in a stack. If six-digit access codes
which use one digit for the Node ID are to be used, the application servers are limited
to Node IDs one (1) to nine (9). This results in a maximum of nine (9) application
servers (primaries and secondaries) in a stack. Because media servers do not store
conferences, you can still have up to 99 of them in a stack even though six digit Access
Codes are specified.
If using remote sites which are bridged together using PSTN, enter the telephone
number (Stack Phone for Remote Sites) used by remote OmniTouch ACS sites to
bridge together distributed conferences (the phone number other sites call to bridge
their servers to this site’s servers).
........................................................................................................................................................................................................................
4 Select whether this server is to be an Application Server, a Media Server, or both. See
the OmniTouch My Teamwork Unified Conferencing and Collaboration Application Site
Preparation Guide for a complete explanation of Application and Media Servers.