Alcatel-Lucent OmniTouch - To Configure Video Settings; Video Settings

............................................................................................................................................................................................................................................................
Video settingsSystem Configuration
2-14
8AL90208USAD ed01
November 20, 2008
............................................................................................................................................................................................................................................................
Video settings
If you are licensed for the Video feature, you can configure video conferencing on the
General Video MCU Settings page. You can use any SIP video client installed on your
PC, provided the client is supported by the Radvision Scopia video multipoint control unit
(MCU). An example of a third-party client is the Counterpath Eyebeam (SIP client).
Notes:
•
Peer-to-peer (P2P) calls require a SIP client.
• The Polycom MGC MCU is not supported for new sales of My Teamwork
beginning with release 5.0. With release 5.0 or greater, only the Radvision Scopia is
supported.
• Voice-activated video switching is not supported by OmniTouch
My Teamwork at this time.
• A single OmniTouch ACS 7.1.4 media server can only communicate with a single
Video MCU. However, multiple media servers in a stacked configuration can each
have their own MCU. If you have multiple Video MCUs and you want
OmniTouch ACS to communicate with them, they must be configured to appear
as a single (virtual) Video MCU. Contact your video equipment vendor for
feasibility and/or specifications for configuring multiple Video MCUs as one.
To configure video settings
........................................................................................................................................................................................................................
1 Select the Configuration tab.
........................................................................................................................................................................................................................
2 Select the Video Settings item.
The General Video MCU Settings dialog box appears.