Alcatel-Lucent OmniTouch - To Install the Secondary Server

To install the Secondary serverManagement Actions
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
3-15
............................................................................................................................................................................................................................................................
To install the Secondary server
........................................................................................................................................................................................................................
1 Disable replication on the Primary server:
a. Click the
Configuration tab.
b. Click the Database Replication item.
c. Uncheck the Enable Replication box.
d. Click the Save button.
........................................................................................................................................................................................................................
2 Replace the old Secondary server with the new Secondary server.
........................................................................................................................................................................................................................
3 Disconnect the Secondary server from the backplane (for example, unplug eth1 cable).
........................................................................................................................................................................................................................
4 Scratch install the New Secondary server to the same software revision as the one used for
the most recent backup. (Refer to the My Teamwork Unified Conferencing and
Collaboration Application Installation Guide for installation procedures.)
........................................................................................................................................................
E ND OF STEPS
To restore configuration settings on the new Secondary
server
........................................................................................................................................................................................................................
1 Log into the Serial Administration console on the new Secondary server:
Username: admin
Password: changeme
........................................................................................................................................................................................................................
2 Configure any required Networking information.
a. Select
Networking Configuration.
b. Use DHCP appears. Select Yes or No and press Enter.
c. Configure your Network appropriately.
d. Reboot the server.