Alcatel-Lucent OmniTouch - To Configure Ldap

To configure LDAPSystem Configuration
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
2-45
............................................................................................................................................................................................................................................................
set up with the default level of authorization to use the system’s special features and will be
able to start using the OmniTouch ACS system immediately. (These defaults are set by the
system administrator, usually during initial configuration.)
If the user requires authorizations that differ from the system defaults, then you can use the
system administrator’s interface to change that user’s profile, (see To modify or delete user
accounts).
OmniTouch ACS 7.1.4 has been certified for use with Sun Microsystems iPlanet Directory
Server and Microsoft’s Active Directory LDAP interfaces.
Note: A Client Connector user on a system that uses LDAP for authentication is
the only user on that system to use the internal ACS authentication instead of LDAP
for authentication.
To configure LDAP
........................................................................................................................................................................................................................
1 Select LDAP.
The LDAP Configuration page for that specific Domain appears.