Alcatel-Lucent OmniTouch - Backup Settings Verification; Using a Dedicated NIC Card for Backups

Using a dedicated NIC card for backupsSystem Configuration
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
2-71
............................................................................................................................................................................................................................................................
Figure 2-37 Backup Settings Verification
........................................................................................................................................................................................................................
11 If you receive no error messages, click Save.
If you receive an error message, check the backup server path.
........................................................................................................................................................
E ND OF STEPS
Using a dedicated NIC card for backups
If your ACS server has a separate NIC card for backups, you need to configure ACS to use
this card to send data to the destination location.
To configure a separate NIC card for backups
........................................................................................................................................................................................................................
1 Click the Configuration tab.
........................................................................................................................................................................................................................
2 Click the TCP/IP Settings item.
........................................................................................................................................................................................................................
3 Enter the IP Address and Net Mask of the additional Ethernet interface.
Do not assign any SIP or RTP use.
........................................................................................................................................................................................................................
4 Click Configuration–>Advanced Settings–>Route Management.
........................................................................................................................................................................................................................
5 Add the subnet and force routing through this additional Ethernet interface.