Alcatel-Lucent OmniTouch - Server Status; Data Replication States

Server statusMonitoring
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
5-17
............................................................................................................................................................................................................................................................
Table 5-3 Data Replication States
Outgoing
– Data created on this server, sent to backup.
Incoming – Data created at backup, sent to this server.
Each data transaction goes through the following states:
New – Client just created data to be replicated.
Queued – Data readied for replication.
Pending – Data sent to backup, awaiting reply status.
Done – Success (an outgoing and incoming count appears).
OR
Error – Failure (an outgoing and incoming count appears).
Server status
The software in OmniTouch ACS is comprised of a number of processes, each one referred
to as a “server”. Each of these server processes is managed by a software watchdog to assure
proper operation. Under certain error conditions, it may be necessary to restart individual
server processes in OmniTouch ACS. This should be done only under the supervision of
your support representative.
State Definition
NOT CONNECTED Database replication is
not happening.
IN PROGRESS Servers are trying to
establish database
replication.
CONNECTED Database replication is
working.