............................................................................................................................................................................................................................................................
Restoring after replacement of the Primary serverManagement Actions
3-8
8AL90208USAD ed01
November 20, 2008
............................................................................................................................................................................................................................................................
Restoring after replacement of the Primary server
This procedure assumes that a stacked system has been in operation for a while, and
regularly scheduled backups have been made. It also assumes that replacement of the
Primary server is required, and while the Primary is down, normal operation has been
taken over by the Secondary server.
There are three procedures that must be performed:
• Initial installation of the Primary
• Restoration of the configuration settings on the Primary
• Replication of the database from the Secondary to the Primary
To install the Primary server
........................................................................................................................................................................................................................
1 Disable replication on the Secondary server:
a. Click the Configuration tab.
b. Click the Database Replication item.
c. Uncheck the Enable Replication box.
d. Click the Save button.
........................................................................................................................................................................................................................
2 Replace the old Primary server with the new Primary server.
........................................................................................................................................................................................................................
3 Disconnect the Primary server from the backplane (for example, unplug eth1 cable).
........................................................................................................................................................................................................................
4 Scratch install the New Primary server to the same software revision as the one used for
the most recent backup. (Refer to the OmniTouch My Teamwork Unified Conferencing
and Collaboration Application Installation Guide for installation procedures.)
........................................................................................................................................................
E ND OF STEPS
To Next Page
Loading...
