Alcatel-Lucent OmniTouch - Restoring an Alliance Server; Manual Server Restore; To Correct Ethernet Mapping

Restoring an Alliance serverManagement Actions
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
3-5
............................................................................................................................................................................................................................................................
Figure 3-2 Manual Server Restore
Before a system can be restored, it must be properly licensed. If restoration starts with a
scratch install, your license must be reapplied using the licensing page before restoring a
saved system.
Restoring an Alliance server
If you are replacing your server with an Alliance system or are fully restoring an existing
Alliance system (for example, due to replacement of an Ethernet card), an unwanted
Ethernet interface name swap may take place.
To correct Ethernet mapping
........................................................................................................................................................................................................................
1 Log into the Serial Administration console on the new server.
Username: admin
Password: changeme