Alcatel-Lucent OmniTouch - PSTN Trunk Settings; To Configure Pstn Trunk Settings

............................................................................................................................................................................................................................................................
PSTN trunk settingsSystem Configuration
2-8
8AL90208USAD ed01
November 20, 2008
............................................................................................................................................................................................................................................................
Note: Ensure that your Domain Name contains valid characters. An invalid
character is an underscore (_). Refer to the following Microsoft® technote found at
http://support.microsoft.com/default.aspx?scid=kb;EN-US;Q275033
“Cookies Are Not Saved If the Host Name Is Invalid.”
........................................................................................................................................................................................................................
4 If you have more than 2 interfaces (up to eth09), provide the IP Address and Netmask for
each additional interface in the grid that appears. Indicate if the interface will route
information using SIP or RTP.
Note: You must reassign routing (SIP or RTP) to another interface before removing
a NIC card that is currently being used to route information.
........................................................................................................................................................................................................................
5 Click the Save button.
........................................................................................................................................................
E ND OF STEPS
PSTN trunk settings
You can configure the T1 or E1 trunks attached to your server.
Note: If your server is VoIP only, and does not use PSTN trunks for voice traffic,
this menu choice will not be shown.
To configure PSTN trunk settings
........................................................................................................................................................................................................................
1 Select the Configuration tab.
........................................................................................................................................................................................................................
2 Select the PSTN Trunk Settings item.
The telephone
Global Parameters page appears.