Alcatel-Lucent OmniTouch - Serial Console

............................................................................................................................................................................................................................................................
To install the standalone serverManagement Actions
3-22
8AL90208USAD ed01
November 20, 2008
............................................................................................................................................................................................................................................................
To install the standalone server
........................................................................................................................................................................................................................
1 Replace the old server with the new server.
........................................................................................................................................................................................................................
2 Scratch install the new server to the same software revision as the one used for the most
recent backup. (Refer to the My Teamwork Unified Conferencing and Collaboration
Application Installation Guide for installation procedures.)
........................................................................................................................................................
E ND OF STEPS
To restore configuration settings on the new server
........................................................................................................................................................................................................................
1 After the installation of the server is complete and server reboots, log into the Serial
Administration console:
Username: admin
Password: changeme
Figure 3-13 Serial Console
........................................................................................................................................................................................................................
2 Configure any required networking information.
a. Select
Networking Configuration.