Alcatel-Lucent OmniTouch - Page 161

To restore configuration settings on the new serverManagement Actions
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
3-23
............................................................................................................................................................................................................................................................
b. Select the Configure TCP/IP network parameter item.
c. Use DHCP appears. Select Yes or No and press Enter.
Figure 3-14 Use DHCP
d. Configure your Network appropriately.
e. Reboot the server.
........................................................................................................................................................................................................................
3 Log into the Web Administration page on the server and upload the license obtained
when the system was purchased.
a. Click the Configuration tab.
b. Click the Licensing item.
c. Locate the license file by using the Browse button.
d. Click the Upload button.
........................................................................................................................................................................................................................
4 Restore the server’s configuration.
a. Click the Configuration tab.
b. Click the Manual Server Restore item.
c. Click the
Browse button to locate the *.md5 file from the latest backup of the
server.
d. Click the Restore button.
e. Click the OK button in the resulting message dialog box.
f. In the
Files that need to be uploaded box, click the Browse button to select the
*.a* files from the latest backup of the server.
Note: There may be multiple files with the following sequential extensions: *.aa,
*.ab, *.ac, etc. The file names will appear on the Administration screen. You must
locate (by using the Browse button) and upload each individual file.
After all files are uploaded, the server automatically restores, and after restoration, the
system will reboot.