Alcatel-Lucent OmniTouch - Page 149

To restore configuration settings on the new Primary
server
Management Actions
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
3-11
............................................................................................................................................................................................................................................................
Password: changeme
........................................................................................................................................................................................................................
6 Configure any required networking information.
a. Select Networking Configuration.
b. Use DHCP appears. Select Yes or No and press Enter.
c. Configure your Network appropriately.
d. Reboot the server.
........................................................................................................................................................................................................................
7 Log into the Web Administration console on the Primary server and upload any licenses
obtained when the system was purchased.
a. Click the Configuration tab.
b. Click the Licensing item.
c. Locate the license file by using the Browse button.
d. Click the Upload button.
e. You need to provide and upload your own VMware license, if you are licensed for
Application Sharing.
........................................................................................................................................................................................................................
8 Verify/change any TCP/IP settings.
a. Click the Configuration tab.
b. Click the TCP/IP Settings item.
c. After data is verified or changed, click the Save button.
Note: Yo u m u s t c l i c k SAVE, even if no data was changed because this page must be
saved for complete restoration to take place.
........................................................................................................................................................................................................................
9 Configure E-mail appropriately.
a. Click
Configuration.
b. Click the System Options item.
c. Configure E-mail settings.
d. Click the Save button.
Note: Yo u m u s t c l i c k SAVE, even if no data was changed because this page must be
saved for complete restoration to take place.
........................................................................................................................................................
E ND OF STEPS