Chapter 26: Policy-Based QoS Commands
486 Section IV: Security and Traffic Control
sendtomirror
Specifies yes, no, or none to the state that mirroring is enabled on
the packets the match the conditions of the classifiers.
trafficclasslist
Specifies a list of traffic classes. To specify multiple classifiers, use
a comma (,) to separate them. To specify a range of classifiers,
use a hyphen (-).
redirectport
Specifies a port number to the traffic is forwarded from.
port_mumber
Specifies a port number.
ingressport
Specifies a list of input ports that the QoS policy is applied to. The
port can be an ingressport to only one QoS policy.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
egressport
Specifies an input port that the QoS policy is applied to. The port
can be an egressport to only one QoS policy.
Description
Use this command to change the settings of the QoS policy.
Confirmation Command
“SHOW QOS POLICY” on page 494
Example
The following command changes the ingressport of QoS policy 1 to port 2:
Manager > set qos policy=1 ingressport=2
To Next Page
Loading...
Need help?
General
