Maintenance-Object Repair Procedures
555-233-143
8-294 Issue 1 May 2002
Figure 8-5 on page 8-217 and Figure 8-6 on page 8-218 show a diagrams of this
2-part test, substituting “CES mode” for “PNC mode.”
Table 8-129. ATM Board Framer Loop-Around Test (#1260)
Error
Code
Tes t
Result Description / Recommendation
1002 ABORT Time slots could not be allocated. Traffic could be heavy or time slots could be
out-of-service.
1. Run display errors, and perform repairs associated with TDM-BUS errors.
2. Retry the command up to 3 times at 1-minute intervals.
1003 ABORT Tone receiver could not be allocated.
1. Run display errors, and perform the repairs associated with TTR-LEV and
TONE-PT errors.
The test cannot run unless there is at least one Tone Detector available in
the EPN that holds the ATM-TRK circuit pack.
2. Retry the command up to 3 times at 1-minute intervals.
1015 ABORT ATM-TRK circuit pack not busied out
1. Busyout the ATM circuit pack.
2. Rerun the command.
1033 ABORT ATM-TRK circuit pack not found
1. See if the switch can see the circuit pack. Run status trunk group.
2. Retry the command.
1139 ABORT Major alarm on the EPN’s packet bus
1. Run display alarms, and perform the repairs associated with PKT-BUS
errors.
2. Run display errors, and perform the repairs associated with PKT-BUS
errors.
3. Retry the command.
1141 ABORT Packet-interface circuit pack out of service
1. See ‘‘PKT-INT (Packet Interface)’’.
1394 ABORT ATM-TRK circuit pack out of service
1. Run the ATM Board Reset test (#1256).
2000 ABORT Request timed out.
1. Retry the command up to 3 times at 1-minute intervals.
2060 ABORT Packet-bus link has failed.
1. Retry the command up to 3 times at 1-minute intervals.
2. If the test continues to abort, run display errors, and perform the repairs
associated with PKT-INT errors.
Continued on next page
To Next Page
Loading...
