ATM-TRK (Circuit Emulation Service Circuit Pack)
Issue 1 May 2002
8-297555-233-143
ATM Board Time Of Day Update (#1261)
The nondestructive ATM-TOD-UPD test updates the system time used by the
ATM-TRK circuit pack for SDH/SONET performance monitoring and synchronizes
the ATM-TRK circuit pack with the S8700 Multi-Connect system’s clock. This test
is run during initialization, scheduled maintenance, and craft long test.
Table 8-130. ATM Board Time Of Day Update (#1261)
Error
Code
Tes t
Result Description / Recommendation
2031 FAIL The attempt to send the message to the ATM-TRK circuit pack was not
successful.
2500 FAIL Internal system error. Did not send the time-of-day information to the board.
1. Retry the command up to 3 times at 1-minute intervals.
2. If the test aborts with the same error code, escalate the problem.
PASS The ATM-TRK circuit pack is successfully updated with system time.
1. If the status port-network command still indicates that this link is down, it
is possible that one or both of the ATM-TRK circuit packs have been
busied out.
2. If the link still does not come up, reset one or both ATM-TRK circuit packs
on the link.
0NO
BOARD
No board detected.
1. Check the error log for wrong board (Error 125) or no board (Error 131).
Resolve either of these issues, if applicable.
2. Check that the board is properly translated and inserted. If so, check for
hyperactivity (Error 1538). If hyperactive, use the reset board UUCSS
command.
1. Run the test again. If it fails, the board could be bad. Replace the board
and retest.
Continued on next page