Maintenance-Object Repair Procedures
555-233-143
8-312 Issue 1 May 2002
Error Log Entries and Test to Clear Values
Notes:
a. Error Type 1 with Aux Data 57481 indicates a port fault. Use an empty port
if one is available until the circuit pack can be replaced.
b. Error Type 1 or 769 with Aux Data 57482 indicates a fault on signaling lead,
which is an off-board error. This error should only occur with loudspeaker
paging. If the trunk is being used for another application, check that the
administration is correct. Otherwise, check the wiring to the external
equipment connected to the Auxiliary Trunk and check the external
equipment.
c. This is a software audit error that does not indicate any hardware
malfunction. Run short test sequence, and investigate associated errors.
d. Indicates the circuit pack has been removed or has been insane for more
than 11 minutes. To clear the error, reseat or replace the circuit pack.
Table 8-135. Auxiliary Trunk Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/
Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate test’s
description, and follow its recommended procedures.
0Any Any Anytest port UUCSSpp sh r 1
1(a) 57481 None
1(b) 57782
15(c) Any Audit Update test (#36)
18 0 busyout port UUCSSpp WARNING OFF release port UUCSSpp
130(d) None WARNING ON test trunk grp/mbr sh
769(b) 57482 None
257 Hybrid/Conference MINOR
WARNING
2
2. Major or Minor alarms may be downgraded to Warning alarms based on the values used in the set options
command.
ON test port UUCSSpp l r 3
Circuit test (#33)
513 NPE Crosstalk test (#6) MINOR
WARNING
2
ON test port UUCSSpp l r 3
1025 Diagnostic test —
Auxiliary Trunk test
(#114)
WARNING ON test port UUCSSpp sh r 3
To Next Page
Loading...
