Avaya S8700 - Page 107

ATM Tips
Issue 1 May 2002
4-33555-233-143
a. If the customer is providing an Ethernet connection to the A500,
does the Ethernet IP address field have the customer-provided
Internet address (configured using the admin address command)?
You can administer the A500 through a Telnet connection over the
Ethernet, but it is worthwhile making sure the Ethernet address is
correct.
b. If the customer is providing an Ethernet connection to the A500,
does the Ethernet IP mask field have the customer-provided
mask (typically something like 255.255.255.0, although other
values are valid), as configured with the admin address command?
c. If the customer is providing an Ethernet connection to the A500,
does the IP default router field have the customer-provided
Internet address, as configured using the admin gateway
command?
d. If the customer is providing an Ethernet connection to the A500 and
intends to upload to or download from a TFTP server, does the TFTP
server field have the customer-provided Internet address, as
configured using the tftp setserver command?
e. Does the ATM address field have the customer-provided or
Avaya-provided network prefix (the first thirteen bytes, set by using
the modify atmprefix command)?
S8700 Multi-Connect Administration
Is ATM PNC administered correctly?
1. Enter list atm pnc on the S8700 Multi-Connect’s SAT. The cabinet, carrier,
and slot positions of each administered TN230X board display as shown in
Figure 4-9. Ensure that each board’s physical location matches the
display.
Figure 4-9. Screen output for list atm pnc command
Alternatively, use the list configuration UUC command (non-control
cabinets) to confirm the EPN’s board locations and correct insertion.
list atm pnc Page 1 SPE A
ATM PNC
PNC A-PNC B-PNC
Connection # LOC LOC
1 01B02
2 02A01