Alarms, Errors, and Troubleshooting
555-233-143
4-40 Issue 1 May 2002
Figure 4-18. Screen output from the show signaling routes command
Check that the Address field (administered using the admin signaling
route add command) matches those administered in S8700
Multi-Connect.
3. If the A500 was administered using End System Identifiers, enter show
signaling esi on the A500 console. Figure 4-19 shows the command
output.
Figure 4-19. Screen output A500: show signaling esi command
Check that the Addresses registered (use the admin signaling esi
add command) match those administered in S8700 Multi-Connect.
■ If an address or End System Identifier is missing or incorrect on the
A500 port associated with the IPSI-connected EPN, the EAL and
PACL links will come up, but 1-way talk paths may result. (The ATM
network can route from the IPSI-connected EPN to another EPN,
which creates the bidirectional EAL and PACL signaling channels
and one side of the talk path.)
A500:show signaling routes
Number of Local Static Routes Allowed: 30
Current number of Local Static Routes: 2
Address: 47.00.05.80.ff.e1.00.00.00.f2.07.2a.01.00.00.00.00.00.00.00
mask:152 cost: 0 node:self port:A1.2 state:UP
Address: 47.00.05.80.ff.e1.00.00.00.f2.07.1b.02.00.00.00.00.00.00.00
mask:152 cost: 0 node:self port:A1.1 state:UP
A500:show signaling esi
Addresses registered on A1.1
----------------------------
* 45.0001.01303538105300000000.000000000011.00
Addresses registered on A1.2
----------------------------
* 45.0001.01303538105300000000.000000000012.00
( * - configured )
To Next Page
Loading...
