Avaya S8700 - Page 1154

Maintenance-Object Repair Procedures
555-233-143
8-432 Issue 1 May 2002
1-3 FAIL DTMF digits were not detected correctly. This may or may not impact reception
of R2-MFC calls.
1. Run the short test sequence via the test port UUCSSpp sh r 1 command.
2. If the problem persists, the system is still operating properly but capacity
will be reduced. To restore performance to normal, replace the call
classifier circuit pack containing the defective CLSFY-PT (Call Classifier
Port).
102 FAIL 2225-Hz Modem Answer tone was not detected correctly. This will impact
call-classification operation.
1. Run the short test sequence via the test port UUCSSpp sh r 1 command.
2. If the problem persists, the system can still operate properly but capacity
will be reduced. In order to restore performance to normal, replace the call
classifier circuit pack containing the defective port.
130 FAIL Forward or backward R2-MFC signals were not correctly generated or
detected. This will impact R2-MFC calls.
1. Run the short test sequence via the test port UUCSSpp sh r 1 command.
2. If the problem persists, the system can still operate properly but capacity
will be reduced. In order to restore performance to normal, replace the call
classifier circuit pack containing the defective port.
PASS Tone detection verification is successful. The call classifier port is able to
detect and generate every necessary tone.
Table 8-176. Test #42 Tone Detection Verification Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page