Avaya S8700 - Page 1232

Maintenance-Object Repair Procedures
555-233-143
8-510 Issue 1 May 2002
Table 8-206. Test #7 Conference Circuit Test
Error
Code
Tes t
Result Description / Recommendation
ABORT Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required for this test were not available. The port may be
busy with a valid call.
1. Use display port UUCSSpp to determine the trunk group/member number
of the port. Use status trunk to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
2. If the port status is active but the port is idle (no calls), check the error log
for Error Type #1025. The port may be locked up.
3. If the port status is idle, retry the command at 1-minute intervals up to 5
times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions, or it may have time slots out of service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic and
the port status is idle, retry the command at 1-minute intervals up to 5
times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out of service.
1. Issue the list measurements tone-receiver command to display
information about the tone receivers.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
times.
1004 ABORT The port was seized by a user for a valid call.
1. Use display port UUCSSpp to determine the trunk group/member number
of the port. Issue the status trunk command to determine the service
state of the port. If the port is in use, wait until it is idle before testing.
2. If the port status is idle, retry the command at 1-minute intervals up to 5
times.
Continued on next page