DID-TRK (Direct Inward Dial Trunk)
Issue 1 May 2002
8-523555-233-143
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port UUCSSpp to determine the station extension,
attendant number, or trunk group/member number of the port. Use
status station, status attendant, or status trunk to determine the
service state of the port. If the port is in use, wait until it is idle before
testing. Attendants are always in use (off-hook), if the handset is plugged
in and the port is not busied out.
2. Retry the command at 1-minute intervals up to 5 times.
1018 ABORT Test disabled via administration. Verify that the Maintenance Tests?
field on the Trunk Group Form is set to
n. To enable the test, issue the
change trunk-group x command (x is the trunk group number). Then
change the entry in the Maintenance Tests? field to y.
2000 ABORT Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT System resources required to run this test are not available. This may be due
to the port being seized.
1. This abort code is usually associated with tone-clock (TONE-BD,
TONE-PT, and TDM-CLK) resources. Clear any tone errors in the error
log.
2. Retry the command at 1-minute intervals up to 5 times.
Table 8-210. Test #33 Loop-Around and Conference Circuit Test — Continued
Error
Code
Te s t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
