ATM Tips
Issue 1 May 2002
4-51555-233-143
3. If connections are being rejected, the Last Cause Code may suggest
why. The cause code (in following Table 4-6) indicating the error may be
on the PPN port even though the EPN port is the one misbehaving, and
vice versa.
Enter show signaling cause causecode on the A500 console. Figure
4-30 shows the screen output for this command.
Figure 4-30. A500:show signaling cause 31
4. At the S8700 Multi-Connect SAT type display errors, and press Enter.
Set the Error List to errors and Category to PNC on the input screen
(Figure 4-31), and press Enter to display any cause codes (see following
Table 4-6) returned from the ATM network to a TN230X on the PPN (and to
a TN230X on an EPN). This is successful only if the links between the
PPN and the EPN remain up so that the message from the EPN is logged.
Refer to ‘‘ATM-BCH (ATM B-Channel Trunk)’’ on page 8-168 for detailed
information about cause codes for this MO.
A500:show signaling cause 31
Cause 31: Normal, unspecified
To Next Page
Loading...
