Avaya S8700 - Page 1435

DS1 CONV-BD
Issue 1 May 2002
8-713555-233-143
Table 8-276. Test #790 DS1 Facilities Connectivity Loop-Back Test
Error
Code
Tes t
Result Description / Recommendation
2000 ABORT Timed out while waiting for a response from the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
2300 ABORT The downlink message necessary to run this test could not be sent.
2301 ABORT The timer could not be set before sending the downlink message necessary to
run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered. Administer the DS1 CONV fiber link via the add
fiber-link command.
2321 ABORT DS1 CONV circuit pack is not busied out. Busyout the DS1 CONV circuit pack
via the busyout board command.
2332 ABORT With this system configuration (unduplicated PNC), the test was aborted
because it cannot be run at the far end when there is only one DS1-FAC
available. (The link would be lost, and no test results would be seen at the
media server.) Run the test at the other end of the DS1C complex.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
Continued on next page