E-DIG-STA (Emulated Digital Line)
Issue 1 May 2002
8-727555-233-143
Hardware Error Log Entries and
Test to Clear Values
Notes:
a. Maintenance personnel have busied out the port in question. Make sure
that the port is released from busyout by using the release port UUCSSpp
command.
b. The circuit pack has been removed or has been insane for more than
21 minutes. To clear the error, reinsert or replace the circuit pack.
c. Problems transmitting to the voice terminal. This problem can be caused
by defective wiring that can cause varying degrees of problems on different
types of sets. Sets such as the 7410 appear to be more susceptible to
wiring problems than others.
Table 8-282. Digital Line Error Log Entries - E-DIG-STA
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate test’s
description, and follow its recommended procedures.
0 Any Any Any test port UUCSSpp sh r 1
18 (a) 0 busyout port
UUCSSpp
WARNING OFF rel port UUCSSpp
130 (b) None WARNING ON test port UUCSSpp sh
257 (c) 40971 None
1537 (d) 40968 None WARNING OFF
1793 (e) Voice and Control Local
Loop test (#13)
MINOR
WARNING
2
2. Major alarms may be downgraded to Warning alarms based on the value used in the set options command.
ON test port UUCSSpp l r 3
2049 (f) NPE Crosstalk test (#9) MINOR
WARNING
2
ON test port UUCSSpp l r 3
2305 (g) 32770 None
3840 (h) 40965 None
3841 (i) 41029 None
2304 (j) None
Continued on next page
To Next Page
Loading...
