E-DIG-STA (Emulated Digital Line)
Issue 1 May 2002
8-733555-233-143
7 FAIL Conference test failed on primary channel. In some cases, users may not
notice disruption in service. In extreme cases, conferencing feature may not
work at all.
14 FAIL The primary voice channel is not transmitting properly. User impact may range
from noticing nothing to not being able to use this port.
15 FAIL The control channel between the Processor and Digital circuit pack is not
transmitting properly. User impact may range from noticing nothing to not
being able to use the port. This could disrupt other users.
16 FAIL The secondary voice channel is not transmitting properly. User impact may
range from noticing nothing to not being able to use this port.
1. Run circuit pack tests to check the Tone Generator circuit pack and the
Tone Detector circuit pack using the test board UUCSSpp command.
2. Resolve any problems that are detected on the Tone Generator circuit pack
or Tone Detector circuit pack.
3. If the test still fails, replace the Digital Line circuit pack.
PASS The test passed, and every channel is transmitting properly.
1. To ensure that this is not an intermittent problem, repeat this test up to 10
times.
2. If noisy connections for voice or corrupted data for data transfer persist,
examine the station, connections, and wiring.
Table 8-284. Test #13 Voice and Control Channel Local Loop Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
