Avaya S8700 - Page 1472

Maintenance-Object Repair Procedures
555-233-143
8-750 Issue 1 May 2002
2000 ABORT Did not receive circuit pack test response within the allowable time period.
1. Reset the circuit pack (busyout board UUCSS, reset board UUCSS, and
release board UUCSS).
2. If the test fails again, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. Escalate if the problem persists.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
1003 FAIL Ping to the destination failed due to on-board problem.
1. Retry the command at 1-minute intervals, up to 3 times.
2. If the problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and release board UUCSS).
3. If the problem persists, re-administer the ethernet connection through a
different ethernet port, if available.
4. If the problem still persists, or if there are no other available ethernet ports,
replace the circuit pack.
1007 FAIL Ping to the destination failed due to the destination down.
1. Verify that at least one destination reachable through this port is up. Ping
this destination (ping ip-address xxx.xxx.xxx.xxx).
2. If the ping to any destination is successful through this port, the link is up,
although some destinations are unreachable. Ignore the failure.
3. If ping to every destination fails, test this port (test port UUCSSpp short),
and follow repair procedures for Session Status test (#1286) failures.
PASS TCP/IP Ping test (#1281) is successful.
Table 8-293. Test #1281 TCP/IP PING Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page