Avaya S8700 - Page 1574

Maintenance-Object Repair Procedures
555-233-143
8-852 Issue 1 May 2002
140 FAIL The Endpoint 1 SNI is physically connected to a DS1 CONV but is not
administered to be connected to a DS1 CONV. (The list fiber-link command
displays a fiber link’s endpoints.) Either add the DS1 converter complex to the
fiber that this SNI is associated with by:
1. Check for the fiber that this SNI is an endpoint of by checking list
fiber-link.
2. Remove fiber-link for the fiber that this SNI is an endpoint of.
3. Add the fiber back via add fiber-link and this time administer the DS1
converter complex also. Or, remove the DS1 CONV connection and
connect the SNI directly to its administered fiber endpoint by entering list
fiber-link and verifying that the fiber-optic and metallic cable connections
are installed as administered.
202 FAIL The SNI circuit pack (Endpoint 2) cannot communicate with the equipped SNI
in slot 2. (The list fiber-link command displays a fiber link’s endpoints.)
1. Perform the ‘‘Fault Isolation for Fiber Links’’ on page 4-19. This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 1, replace the SNI being
tested. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.) To view SNI-PEER
errors, use the display errors command with category PNC-PEER. Retry
the command.
3. If the SNI being tested still has SNI-PEER Error Type 1, replace the SNI in
slot 2.
203 FAIL The SNI circuit pack (Endpoint 2) cannot communicate with the equipped SNI
in slot 3. (The list fiber-link command displays a fiber link’s endpoints.)
1. Perform the ‘‘Fault Isolation for Fiber Links’’ on page 4-19. This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 257, replace the SNI
being tested. (Replacing an SNI may be service interrupting. Refer to the
SNI-BD section for the procedure to replace an SNI.) To view SNI-PEER
errors, use the display errors command with category PNC-PEER. Retry
the command.
3. If the SNI being tested still has SNI-PEER Error Type 257, replace the SNI
in slot 3.
Table 8-328. Test #759 Configuration Audit — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page