FW-DWNLD (Firmware Download)
Issue 1 May 2002
8-875555-233-143
2. The example in Screen 8-5 shows PASS in the Result field, indicating a
successful test of the firmware download circuitry.
If the system does a reset 1 or 2 and no alarms are present:
1. At the SAT, type display initcauses and press
return.
2. Clear any errors
3. At the SAT, type test firmware download and press
return to retest.
So far you have copied the new firmware file to the desired location. Now you set
the firmware image, “pointing” the system to the desired firmware image file:
1. At the SAT, type set boot-image board location image-1/image-2 and
press
return.
Example: set boot-image board 1C07 2
NOTE:
The new firmware image file resides in image-2 after a successful
download. In most cases use image-2 as the new firmware image
file.
The system responds with Command Successfully Completed.
2. Reseat the circuit pack to activate the new firmware image:
!
WARNING:
To prevent electrostatic discharge (ESD), be sure to wear a
grounding strap while handling the circuit pack.
a. Lift the latch handle to free the circuit pack from the carrier.
b. Pull the circuit pack clear of the backplane.
c. Re-insert the circuit pack into the carrier.
d. Close the latch securely.
Wait until all 3 of the top LEDs (red, green, and amber) are out.
3. At the SAT type get boot-image location and press
return to check the
status of the firmware images on the TN2501AP circuit pack.
The Display Firmware Image(s) report (Screen 8-6) appears.
To Next Page
Loading...
