Avaya S8700 - Page 1658

Maintenance-Object Repair Procedures
555-233-143
8-936 Issue 1 May 2002
Table 8-362. Test #53 SAKI Sanity Test
Error
Code
Test
Result Description / Recommendation
None ABORT System resources required for this test are not available.
Retry the command at 1-minute intervals up to 5 times.
1015 ABORT Port is not out of service.
1. Busy out the circuit pack.
2. Execute command again.
2100 ABORT System resources required for this test are not available.
Retry the command at 1-minute intervals up to 5 times.
2803 ABORT It is necessary to reset the board.
1. Use the change ip-interfaces form to disable the Media processor IP
interface.
2. Execute the command again.
1 FAIL The circuit pack failed to reset.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
2,
2000
FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The circuit pack initializes correctly.
Run the short test sequence.
Any NO
BOARD
This is normal if the test is being done when (a) the board is not physically in
the system or (b) the system is booting up. Otherwise, there is some
inconsistency between the physical configuration and the data kept in the
system.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals for up to 5 times.
Continued on next page