Avaya S8700 - Page 1660

Maintenance-Object Repair Procedures
555-233-143
8-938 Issue 1 May 2002
NIC Query Test (#1383)
This test is nondestructive.
This test passes if the Ethernet port is connected, and you can talk on the
network. Otherwise, it fails with no fail code or AUX data.
Ping Test (#1379)
This test is a non-destructive test.
This test verifies that the MedPro circuit pack can communicate to other nodes on
the LAN.
Table 8-364. Test #1383 NIC Query Test
Error
Code
Test
Result Description / Recommendation
None ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1015 ABORT Port is not out of service.
1. Enter busyout board UUCSS to busyout the circuit pack.
2. Execute the command again.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Ethernet port is not connected, and you cannot talk on the network.
PASS The Ethernet port is connected, and you can talk on the network.
0NO
BOARD
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board’s translations are correct.
2. If the board is not correctly administered, administer the MedPro interface.
If correctly administered, check the error log to determine whether the
board is hyperactive. If so, the board was shut down. Reseat the board to
re-initialize it.
3. If the board is correctly inserted and administered, issue the busyout
board UUCSS command.
4. Issue the reset board UUCSS command.
5. Issue the release board UUCSS command.
6. Issue the test board UUCSS long command.
This should re-establish the linkage between the internal ID and the port.
Continued on next page