Avaya S8700 - Page 1661

IPMEDPRO (IP Media Processor Circuit Pack)
Issue 1 May 2002
8-939555-233-143
This test also pings the gateway IP address as defined on the IP Interface form. If
the PING is successful, this test looks at the PING round-trip delay. If a round-trip
delay of greater than 4 seconds is reported, a separate error is logged. Excessive
round-trip delays do not take the MedPro out of service.
Services can execute the standard PING command using the C-LAN board
address and MedPro IP address to see the actual round-trip delay. (See ping
commands.)
This test is a non-destructive test. It runs due to in-line errors, during periodic and
scheduled maintenance, and on demand.
Table 8-365. Test #1379 Ping Test
Error
Code
Test
Result Description / Recommendation
1, 2 ABORT Internal Error.
1. Retry the command at 1-minute intervals up to 3 times.
7 ABORT
Destination unreachable.
1. Verify that at least one destination reachable through this port is up.
2. Repeat the test.
3. If the test still aborts, escalate the problem.
2000 ABORT Response to the test was not received from the Media processor circuit pack
within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack. Reset the
circuit pack by issuing the busyout board UUCSS and the reset board
UUCSS commands.
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT The necessary system resources to execute the test could not be allocated.
1. Retry the command at 1-minute intervals up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT No IP address defined. Verify IP interfaces translations and retest.
2802 ABORT Different IP address pinged than software had allocated for the test.
1. Retry the command at 1-minute intervals up to 3 times.
Continued on next page