Maintenance-Object Repair Procedures
555-233-143
8-958 Issue 1 May 2002
See Table 8-377 for ABORT/FAIL codes associated with the set
ipserver-interface command:
Table 8-377. Error codes for set ipserver-interface
Error
Code
Command
Result Description
PASS The interchange was successful, or the set to IPSI was already active. If set
to a B-side IPSI, it will be marked as “craft set” and will not preference switch
back to the A-side by software.
2338 FAIL The SOH of the set-to IPSI is bad. Use list ipserver-interface to display the
current IPSI’s SOH.
2340 The archangel function is not on an IPSI.
2341 An error occurred during the interchange.
2342 The set-to IPSI has been busied out.
Run release ipserver-interface Uc first.
2343 ABORT Interchange not permitted. The anti-thrashing timer has not yet expired.
Retry command in 30 seconds.
To Next Page
Loading...
