EasyManua.ls Logo

Avaya S8700 - Page 1732

Avaya S8700
2618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance-Object Repair Procedures
555-233-143
8-1010 Issue 1 May 2002
2038,
2039
ABORT A problem occurred while trying to read the test data.
1. Wait 1 minute and then try again. If the test aborts again in the same
manner, there is a serious internal problem.
2040 ABORT Internal system error. Follow recommendations for ABORT code 2012.
2041 ABORT The call has timed out, perhaps because of a lack of system resources. Follow
recommendations for ABORT code 2035.
2066 ABORT Could not establish test call.
1. Retry the command at 1-minute intervals up to 5 times.
2067 ABORT The call has timed out, perhaps because of a lack of system resources. Follow
recommendations for ABORT code 2035.
2074 ABORT Bit and Block Error query failed.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, there may be a serious internal problem with
M/T-DIG (Maintenance/Test Digital Port). If this is the case, see‘‘M/T-DIG
(Maintenance/Test Digital Port)’’.
2075 ABORT Internal system error. Follow recommendations for ABORT code 2012.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2104 ABORT Call dropped or could not be originated.
1. Make sure service is provisioned by the network.
2. Check the administration of the far-end test line extension on the trunk
group administration form.
3. Check the administration of the Testcall BCC (Bearer Capability Class) on
the trunk group administration form.
4. Check the reason for termination with status isdn-testcall.
5. For further instructions see ‘‘Troubleshooting ISDN-PRI Test Calls’’.
6. Try the test again.
2201,
2202,
2203,
2204,
2205
ABORT Internal system error. Follow recommendations for ABORT code 2012.
2206 ABORT Could not allocate the necessary system resources to run this test. Follow
recommendations for ABORT code 2100.
2208 ABORT Internal system error. Follow recommendations for ABORT code 2012.
Table 8-400. Test #258 ISDN Test Call Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page

Table of Contents

Other manuals for Avaya S8700

Related product manuals