ISDN-TRK (DS1 ISDN Trunk)
Issue 1 May 2002
8-1011555-233-143
2209,
2210
ABORT Could not allocate the necessary system resources to run this test. Follow
recommendations for ABORT code 2100.
2211 ABORT Internal system error. Follow recommendations for ABORT code 2012.
2212 ABORT Call ended by unexpected disconnect.
1. Wait 1 minute, and then try again.
2213 ABORT The call has timed-out, perhaps because of a lack of system resources. Follow
recommendations for ABORT code 2035.
2214 ABORT Call ended by unexpected disconnect.
1. Wait 1 minute, and then try again.
2215,
2216,
2217,
2218,
2219
ABORT Internal system error. Follow recommendations for ABORT code 2012.
2220 ABORT Call ended prematurely.
1. Wait 1 minute, and then try again.
2221,
2222,
2223,
2224,
2225,
2226
ABORT Internal system error. Follow recommendations for ABORT code 2012.
2227 ABORT Could not allocate the necessary system resources to run this test. Follow
recommendations for ABORT code 2100.
2042 FAIL Comparison of data sent to data received indicates a loss of integrity on the
communications path.
1. Take the trunk out of service and check the quality of the DS1 connection,
including the transmission facility and any external equipment such as
DACs, CSUs, etc. Use test isdn-testcall and status isdn-testcall
commands to get the bit and block error rates.
PASS The test pattern was sent and received properly. If the synchronous test call
was performed (long test sequence), this indicates that the communications
path is operating properly. If the test isdn-testcall command was used, PASS
indicates only that the test call was established. Use the status isdn-testcall
command to get the bit and block error rates detected by the test. If the bit and
block error rates are not acceptable, perform a complete analysis of the DS1
facility including the transmission facility and any external equipment such as
DACs, CSUs, etc.
Table 8-400. Test #258 ISDN Test Call — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page