Avaya S8700 - Page 1749

MAINT (PN’s Maintenance Circuit Pack)
Issue 1 May 2002
8-1027555-233-143
Backplane Connectivity when Installed in a New System
New systems PN Control Carriers have backplane connectivity between the
TN775D Maintenance circuit pack located in slot one of the new PN Control
Carrier and the TN2312AP IPSI circuit pack located in slot two. No face plate
cable is needed.
Error Log Entries and Test to Clear Values
Notes:
a. A value of 0 indicates that PNC-A (and therefore, the Expansion Interface
circuit pack located on PNC-A) was active when this error occurred. A
value of 1 indicates that PNC-B (and therefore, the Expansion Interface
circuit pack located on PNC-B) was active when this error occurred. To
clear this problem, make sure the active PNC is the same as that indicated
by the Aux Value.
Table 8-405. PN’s Maintenance Circuit Pack Error Log Entries
Error
Type
Aux
Data Associated Test Alarm Level
On/Off
Board Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test’s description, and follow its recommended procedures.
0 Any Any Any test maintenance sh r 1
1 (a) 0
1
PN Maintenance Circuit
Pack Reset test (#306)
MINOR ON test maintenance l
513 (a) 0
1
MGR I Channel Loop test
(#228)
MINOR ON test maintenance sh r 3
769 (b) Any Sanity Handshake test
(#106)
1537 (a) 0
1
Sanity Maze test (#303) MINOR ON test maintenance sh r 3
2049 (c) Any Battery Holdover Vintage
Verification Test (#311)
WARNING ON test maintenance sh r 1
2561 (a) 0
1
Sanity Handshake test
(#106)
MINOR ON test maintenance sh r 3
2817 (a) 0(b)
1
Serial Channel Loop test
(#229)
MINOR ON test maintenance sh r 3
3329 (d) Any Serial Link Test (#337) MINOR/
WARNING
2
2. Major and Minor alarms may be downgraded to Warning alarms based on the value used in the set options
command.
OFF test maintenance sh r 3
3585 (e) Any Serial Link Test (#337) MINOR/
WARNING
2
OFF test maintenance sh r 3