Avaya S8700 - Page 1764

Maintenance-Object Repair Procedures
555-233-143
8-1042 Issue 1 May 2002
Backing Up to the PCMCIA Disk
Table 8-414 details how to back up administration data for the IP trunk application
to and restored from the local PCMCIA disk and the Ethernet port. Before backing
up, be sure to shut down the application running on the circuit pack, following the
procedures in the ‘‘Shutting Down NT on the TN802’’ section.
NOTE:
Local restore of a complete system from the PCMCIA disk should not
require more than 20 minutes assuming that a replacement MAPD pack is
available and pre-loaded with the IP trunk application software.
Table 8-414. Backing up TN802 administration data
Step Description Comments
1. Busyout circuit pack At the S8700 Multi-Connect terminal, type
busyout board UUCSS (the address of the
TN802 circuit pack) and press
Enter.
2. Backup administration
TN802 to disk
At the Windows NT desktop, double-click on the IP
Trunk Backup Restore icon.
The IP Trunk Backup/Restore Utility screen
appears.
3. Select utility In the IP Trunk Backup/Restore Utility dialog
screen, click on Files, Backup.
The IP Trunk Backup screen appears.
4. Select backup In the IP Trunk Backup screen, click on the
Backup button
5. Wait Backup can take as much as 20 minutes to
complete.
6. Release circuit pack At the S8700 Multi-Connect terminal, type release
board UUCss (the address of the TN802 circuit
pack) and press
Enter.
Continued on next page