Avaya S8700 - Page 1894

Maintenance-Object Repair Procedures
555-233-143
8-1172 Issue 1 May 2002
1004 ABORT The port was seized by a valid ISDN-PRI test call. Use the list isdn-testcall
command to determine which call is using the port (from the M/T Port column).
Either wait for the test call to complete (as indicated in the
Start Time and
Duration fields of the above display), or abort the test call with the clear
isdn-testcall grp/mem command, where grp/mem is determined from the
B-channel field of the above display.
1019 ABORT An ISDN test call is in progress using this Maintenance/Test circuit pack. The
Maintenance/Test circuit pack cannot perform a self-test on one of its digital
ports while an ISDN test call is using either of the digital ports. Use the list
isdn-testcall command to determine which call is using the port (form the
M/T Port column). Either wait for the test call to complete (as indicated in the
Start Time and Duration fields of the above display), or abort the test
call with the clear isdn-testcall grp/mem command, where grp/mem is
determined from the B-channel field of the above display.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort and the port is idle, escalate the problem.
1138 ABORT This test does not run on port 3 of the Maintenance/Test circuit pack. This test
will only run on port 2. Look at the results of the Digital Port Sanity test for
port 2.
1. Run the command again for port 2 via the test port UUCSS02 or test port
UUCSS02 l command.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
2500 ABORT An internal operation failed; the test could not be completed.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
Table 8-480. Test #565 Digital Port Sanity Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page