Maintenance-Object Repair Procedures
555-233-143
8-1174 Issue 1 May 2002
Hook State Inquiry (#566)
This test ensures that the Maintenance/Test digital port maintenance software and
call processing agree on the on-/off-hook status of the Maintenance/Test digital
port.
Table 8-481. Test #566 Hook State Inquiry
Error
Code
Tes t
Result Description / Recommendation
1 ABORT Switch hook audit timed out. No response was received from the circuit pack
for information about the switch hook state.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, replace the circuit pack and repeat the test.
3. If the test continues to abort, escalate the problem.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
Any FAIL Internal system error. This test should never return a failure.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail reset the circuit pack via the busyout board
UUCSS, reset board UUCSS, and release board UUCSS command
sequence.
3. Retry the command at 1-minute intervals up to 5 times.
4. If the test continues to fail, escalate the problem.
PASS Call processing and Maintenance/Test digital port maintenance software agree
on the Maintenance/Test digital port hook state.
Continued on next page
To Next Page
Loading...
