Avaya S8700 - Page 1978

Maintenance-Object Repair Procedures
555-233-143
8-1256 Issue 1 May 2002
Table 8-509. Test #884 Memory Checksum Test
Error
Code
Test
Result Description / Recommendation
1006,
1137
ABORT Since the IPSI’s Packet Interface circuit is out of service, normal maintenance
tests do not run on the IPSI circuit pack.
1. Enter the reset packet-interface Uc command to reset the Packet
Interface circuit.
For further action, see the repair procedures in Table 8-509 on page
8-1256 for the Packet Interface Reset test (#889).
1334 ABORT The Packet Interface command queue is full. This should be a temporary
condition caused by a high rate of commands being sent to a Packet Interface.
Continued operation with a full command queue would cause a system WARM
restart that may escalate to more severe restart levels.
1. Retry the command at 10-second intervals up to 5 times.
1335 ABORT Internal IPSI error. The Packet Interface is on the standby IPSI, so this test is
not allowed to execute.
1. To run this test on the standby Packet Interface, enter set
ipserver-interface Uc to activate it.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command.
NO
BOARD
The IPSI circuit pack’s Packet Interface circuit is assigned, but is not detected
as being physically present.
1. If the IPSI circuit pack is present, replace it.
2. If not, insert a TN2312AP IPSI circuit pack in the assigned slot, and run the
test again.
Continued on next page