Avaya S8700 - Page 1989

PKT-INT (Packet Interface)
Issue 1 May 2002
8-1267555-233-143
Reset Test (#889)
The reset action initializes the Packet Interface firmware on the IPSI circuit pack
and runs a comprehensive set of diagnostic tests.
The demand reset action will abort if the specified IPSI circuit pack’s Packet
Interface is in the active in-service state.
An IPSI circuit pack’s Packet Interface is put in the out-of-service state
automatically if it has been reset 3 times by background maintenance within the
last 15 minutes, independent of the results of the reset action.
If this is a high- or critical-reliability system and if the Packet Interface is on the
standby IPSI, the demand reset action will run, independent of the service state.
2000 ABORT Response to the test request was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command.
NO
BOARD
The IPSI circuit pack’s Packet Interface circuit is assigned, but is not detected
as being physically present.
1. If the IPSI circuit pack is present, replace it.
2. If not, insert a TN2312AP IPSI circuit pack in the assigned slot, and rerun
the test.
1 FAIL Setting up peer links between the active and standby IPSI circuit pack’s Packet
Interface circuits failed.
1. Use the display alarms command to display active alarms.
2. If errors related to the packet bus exist, see ‘‘PKT-BUS (Packet Bus)’’ on
page 8-1230 to clear those problems first.
3. Retry the test command after a 1-minute delay.
4. If the test continues to fail, replace the standby IPSI circuit pack.
Table 8-513. Test #888 Active-Standby Peer Link Test — Continued
Error
Code
Test
Result Description / Recommendation
Continued on next page